My LX200 Modifications
Current Modifications
Below is a list of all the projects/modificaions I've preformed to my LX200 setup. Feel free to do any of these yourself, but PLEASE NOTE: Some of the modifications WILL void your warranty!
To-Do list:
- Make a new Dew Heater to permenently mount to scope (Already started)
Laser Finder Bracket
This is actually an idea found on another website (Scott's Astronomy Site). As I basicly followed Scotts directions, I will not duplicate them here. I did however do some things different.
I used a 3/4 inch copper T rather than 1/2 inch. I feel this is a better fit for the laser, as it has a diameter of almost 1/2 inch itself. Using a 3/4 inch T gives a little more adjusting room.
I choose not to solder the nuts onto the piece. Instead, I used JB-Weld. I'm beginning to LOVE that stuff!
I found that the nylon screws were still a little loose for my taste, so I wrapped a little teflon tape (what you use for water pipe connections) around them. This made them a bit harder to turn, but then there is no chance of them moving after the adjustment is made.
I used self sticking felt on the bottom plate. This way I will not scuff my telescope when the bracket is mounted and removed.
I have yet to add the rubber strap. I'm still debating what I want to use. I'm toying with the idea of using Velcro, but not sure yet. So as a result, this is as far as I have done.